Yes, This Dramatic Difference Is Expected and the 75 mm Hg Reading Is Accurate
The reading of 75 mm Hg diastolic when your arm was supported on the table at chest level is the accurate measurement, while the 29 mm Hg reading with your arm on the chair arm is falsely low due to improper positioning.
Why This Happens: Hydrostatic Pressure Effects
When your arm is positioned incorrectly during blood pressure measurement, hydrostatic pressure creates significant errors:
- Arm below heart level (hanging down or resting low on chair arm): Readings are falsely elevated by approximately 2 mm Hg for every inch below heart level, potentially 10+ mm Hg total 1
- Arm above heart level (elevated on chair arm): Readings are falsely decreased by the same magnitude 1
In your case, if the chair arm positioned your arm significantly above heart level, this explains the artificially low diastolic reading of 29 mm Hg—a value that would be physiologically incompatible with life if accurate.
The Correct Technique for Omron Devices
Multiple Canadian and American guidelines provide identical instructions 2, 3, 4, 5:
Critical positioning requirements:
- Sit in a chair with back supported and feet flat on floor (legs uncrossed)
- Rest quietly for 5 minutes before measurement
- Arm must be bare and supported at heart level (mid-sternum/fourth intercostal space when sitting)
- The blood pressure cuff itself should be positioned at heart level
- No talking during measurement
- Take at least 2-3 readings, discard the first, and average the remaining readings
Your table measurement at chest level followed these guidelines correctly, which is why it produced the physiologically reasonable reading of 75 mm Hg diastolic.
Common Pitfalls to Avoid
The guidelines specifically warn that a lower arm position results in erroneously higher systolic and diastolic blood pressure 2, 3, 4. The converse is equally true—a higher position produces falsely low readings, as you experienced.
Research confirms this with Omron devices specifically: Studies show that arm position dramatically affects readings, with differences of 8-21 mm Hg in systolic pressure depending on whether the hand is positioned at shoulder level versus elbow level 6, 7.
What To Do Going Forward
Always measure with your arm supported on a table at heart level:
- Sit at a table or desk
- Rest your arm on the surface so the cuff is at mid-chest height
- Support your entire arm from elbow to wrist
- Never let your arm hang down or rest on a chair arm that elevates it above heart level
The 29 mm Hg reading should be disregarded entirely—it represents a measurement artifact, not your actual blood pressure. Use only measurements taken with proper arm positioning at heart level 2, 3, 4, 5.