Radiation Dose from Bone Density Testing
A DXA scan for bone mineral density exposes you to approximately 0.1 to 6.7 microSieverts (μSv) of radiation, which is extremely low—less than one day of natural background radiation and far lower than a standard chest X-ray.
Specific Radiation Doses by Scan Type
DXA (Dual-Energy X-ray Absorptiometry)
The radiation exposure from DXA varies by scanning mode and body site 1, 2:
- Pencil beam DXA: 0.08–4.6 μSv per scan
- Fan beam DXA (Fast Array mode):
- Lumbar spine: 6.7 μSv
- Hip: 4.7 μSv
- Fan beam DXA (Array and High Definition modes):
- Lumbar spine: 13.3 μSv
- Hip: 9.3 μSv
For context, this is extraordinarily low—natural background radiation in most countries delivers approximately 7 μSv per day 3. A single chest X-ray delivers about 100 μSv, and an abdominal X-ray approximately 100 μSv 4.
Peripheral DXA (Forearm)
Forearm bone density measurements using peripheral DXA systems deliver even less radiation—approximately 0.1 μSv per scan 3. This is truly negligible from a radiation safety perspective.
Vertebral Fracture Assessment (VFA)
When DXA is used to assess vertebral fractures (a lateral spine image), the radiation dose remains low at less than 60 μSv, which is still substantially lower than standard lateral spine radiographs 2.
Comparison with QCT
If quantitative computed tomography (QCT) is used instead of DXA for bone density measurement, radiation doses are higher 2, 4:
- Single energy QCT: 25–300 μSv
- Dual energy QCT: approximately 1,000 μSv (1 mSv)
However, QCT is typically reserved for specific clinical situations where DXA is inadequate (severe obesity, extreme height variations, severe degenerative spine disease) 5.
Clinical Implications
Radiation dose should not be a limiting factor in deciding whether to perform DXA for bone density assessment 4. The doses are at the absolute lower end of diagnostic radiology procedures, and the clinical benefits of diagnosing and monitoring osteoporosis far outweigh the minimal radiation risk.
Important Caveats:
- Fast Array mode is preferred when available on Hologic systems, as it provides comparable accuracy to standard Array mode but with approximately half the radiation dose and scan time 1
- Operator exposure from scatter radiation is negligible for pencil beam systems but slightly higher (though still safe) for fan beam systems 2
- The effective dose calculations use the ICRP-60 methodology, which accounts for tissue weighting factors 1, 2