Clinical Steps for Properly Applying an AED
Turn on the AED, expose the patient's chest, apply pads directly to bare skin in the anterolateral position (one below the right clavicle and one on the left midaxillary line), follow the device prompts, and deliver shock when indicated—then immediately resume CPR. 1, 2
Step-by-Step AED Application Protocol
1. Power On the Device
- Turn the AED on first—this activates voice and visual prompts that will guide you through the entire process 3
- The device will provide step-by-step instructions; follow them precisely
2. Prepare the Chest
Critical preparation steps to reduce transthoracic impedance:
- Expose the chest completely - remove all clothing from the torso
- Dry the skin if wet (sweat, water, etc.)
- Remove excessive chest hair if present - quickly shave the pad placement areas if time permits, but do not delay shock delivery 4
- Avoid breast tissue in female patients - place pads lateral to or underneath the breast, not on top of breast tissue 4
3. Apply Pads to Bare Skin
This is where most errors occur 5, 6:
Anterolateral (AL) Position - Standard placement:
- Anterior pad: Place below the right clavicle, just to the right of the upper sternal border
- Lateral pad: Place on the left midaxillary line, below the armpit 4
Common placement errors to avoid 5:
- Placing pads on clothing instead of bare skin (occurs in up to 50% of untrained users) 6
- Placing the anterior pad too low (most common error - 62.5% of incorrect placements) 5
- Placing the lateral pad too low (50-75% of incorrect placements) 5
- Failing to remove pad packaging or protective liner 6
Key technique points:
- Press pads firmly and smoothly to ensure complete contact with skin
- Ensure no air pockets between pad and skin
- Do not overlap pads or place them too close together
4. Follow Device Prompts
- Do not touch the patient during rhythm analysis
- The AED will automatically analyze the rhythm
- Stand clear when the device charges and prompts for shock delivery
5. Deliver Shock (if indicated)
- Ensure no one is touching the patient
- Press the shock button when prompted (or the device will shock automatically if fully automated)
- Immediately resume CPR after shock delivery - do not delay to check pulse 1, 2
6. Continue CPR Cycles
- Perform CPR for 2 minutes (until the AED prompts you to stop for rhythm recheck) 1, 2
- The AED will automatically reanalyze the rhythm every 2 minutes
- Repeat shock delivery if indicated
- Continue until advanced providers arrive or the patient shows signs of life
Alternative Pad Position (If Standard Position Not Feasible)
Anteroposterior (AP) Position 4:
- Anterior pad: Left side of chest, between midline and nipple (avoiding breast tissue in females)
- Posterior pad: Left side of spine, just below the scapula
- This position may be superior for refractory VF after 3 failed shocks in the AL position 4
Critical Pitfalls to Avoid
- Delaying shock delivery - Speed is critical; aim for first shock within 2 minutes of AED arrival 7
- Placing pads on clothing - This is the most common error and prevents effective defibrillation 6
- Incorrect pad positioning - Too low is the most frequent error for both pads 5
- Relying solely on AED prompts without patient assessment - The device can give false alerts 8
- Failing to immediately resume CPR after shock - Chest compressions must restart within seconds 1, 2
- Touching the patient during shock delivery - Ensure everyone is clear
Context-Specific Considerations
For witnessed sudden collapse 1:
- Retrieve AED immediately before starting CPR (if alone and AED is nearby)
- Apply AED as soon as available
For unwitnessed collapse 1:
- Start CPR first, then apply AED when it arrives
- In pediatric cases: perform 2 minutes of CPR before retrieving AED if alone
Healthcare providers vs. lay rescuers 1, 2:
- Both should follow the same basic steps
- Healthcare providers should minimize interruptions in chest compressions during pad application
- Use pediatric pads/settings for children under 8 years if available 1