What infusion rate in mL per hour is needed to deliver 2000 units of Balfaxar (bivalirudin) at 3 units per kilogram per minute with a maximum rate of 210 units per minute?

Medical Advisory BoardAll articles are reviewed for accuracy by our Medical Advisory Board
Educational purpose only • Exercise caution as content is pending human review
Article Review Status
Submitted
Under Review
Approved

Last updated: November 18, 2026 • View editorial policy

Have a follow-up question?

Our Medical A.I. is used by practicing medical doctors at top research institutions around the world. Ask any follow up question and get world-class guideline-backed answers instantly.

Calculating Balfaxar Infusion Rate

To deliver 2000 units of Balfaxar at 3 units/kg/minute (with a maximum rate of 210 units/minute), you need to know the concentration of your reconstituted solution and the patient's weight to calculate mL/hr.

Critical Information Needed

You've provided the dose (2000 units) and the rate parameters (3 units/kg/min, max 210 units/min), but the calculation requires:

  • Patient's weight in kg - to determine if you're at the weight-based rate or hitting the maximum
  • Concentration of reconstituted Balfaxar - which varies from 20-32 Factor IX units/mL depending on the actual potency stated on your specific vial 1

Calculation Framework

Step 1: Determine Your Rate in Units/Minute

If you're administering at the maximum rate of 210 units/minute, this is straightforward.

If you're using the weight-based dosing of 3 units/kg/min, calculate: 3 units/kg/min × patient weight (kg) = units/min (but not exceeding 210 units/min)

Step 2: Convert to mL/hr

Once you know your rate in units/minute:

mL/hr = (units/min × 60 min/hr) ÷ concentration (units/mL)

Example Calculation

If using the maximum rate of 210 units/min with a concentration of 25 units/mL (mid-range):

  • 210 units/min × 60 = 12,600 units/hr
  • 12,600 units/hr ÷ 25 units/mL = 504 mL/hr

Important caveat: Balfaxar is indicated for warfarin reversal, not as a continuous anticoagulant infusion 1. The FDA labeling specifies administration at 0.12 mL/kg/min (3 units/kg/min) up to a maximum of 8.4 mL/min (210 units/min) as a single dose, not a continuous infusion 1. The 2000 unit total dose you mentioned should be given as a one-time infusion, not maintained continuously.

If you're actually asking about bivalirudin (which is used for continuous anticoagulation during PCI), the dosing is completely different: 0.75 mg/kg bolus followed by 1.75 mg/kg/hr infusion 2.

Professional Medical Disclaimer

This information is intended for healthcare professionals. Any medical decision-making should rely on clinical judgment and independently verified information. The content provided herein does not replace professional discretion and should be considered supplementary to established clinical guidelines. Healthcare providers should verify all information against primary literature and current practice standards before application in patient care. Dr.Oracle assumes no liability for clinical decisions based on this content.