Management of Encrusted Ureteral Stents
For encrusted ureteral stents, urologists should employ a multimodal endoscopic approach using ureteroscopy (URS) with Ho:YAG laser lithotripsy as the primary technique, combined with cystolitholapaxy and/or percutaneous nephrolithotomy (PCNL) as needed based on the location and severity of encrustation.
Initial Assessment and Preparation
Before attempting removal, obtain imaging (CT or plain radiography) to assess:
- Location of encrustation (renal pelvis, ureteral body, bladder coil)
- Stone burden size and distribution
- Whether the stent is fragmented
- Degree of ureteral dilation
Ensure urine culture is negative before proceeding - if infection is present, treat with culture-directed antibiotics and delay definitive removal until infection resolves 1.
Treatment Algorithm Based on Encrustation Location
Bladder Coil Encrustation
- Primary approach: Cystolitholapaxy (transurethral endoscopic stone fragmentation)
- This addresses the distal anchor point and allows subsequent removal 2, 3
Ureteral Body Encrustation
- Primary approach: Retrograde ureteroscopy with Ho:YAG laser lithotripsy
- The Ho:YAG laser is the gold standard for stone fragmentation 4
- Use either rigid ureteroscopes (<8F tip) or flexible ureteroscopes depending on stone location 4
- Alternative technique: Cut the encrusted stent directly with Ho:YAG laser using 4.5-Fr semi-rigid or flexible ureteroscopes 5
Renal Pelvis/Upper Coil Encrustation
- Primary approach: PCNL for large stone burden (>15mm) or heavily encrusted upper coils 3
- Alternative: Antegrade ureteroscopy through percutaneous access for impacted stones 4
- Consider ESWL as initial debulking for moderate encrustation, followed by endoscopic removal 3
Specific Endoscopic Techniques
Novel Access Sheath Method
For intact but encrusted stents, the telescopic access sheath technique offers a minimally invasive option:
- Pull the stent through the urinary meatus via rigid cystoscopy
- Advance a modified access sheath (with cut distal obturator) over the retained stent
- The encrustation peels off as the sheath advances, allowing intact removal 6
Nephrostomy-Assisted Removal
When retrograde removal is unsafe due to severe embedding:
- Establish percutaneous nephrostomy for antegrade access
- Use stepwise approach: initial traction assessment, Ho:YAG laser incision to release tissue ingrowth, endoscopic scissors for careful dissection
- Enables controlled en bloc removal while preserving ureteral integrity 7
Expected Treatment Course
Most patients require 2 endoscopic interventions on average to achieve complete stent and stone removal 2. The most common combination is cystolitholapaxy followed by ureteroscopy (41.1% of cases) 2.
All procedures should be completed in a single session when possible to minimize morbidity and hospital stay (mean 1.3 days) 2.
Critical Pitfalls to Avoid
Never attempt removal with active UTI - this can precipitate life-threatening sepsis. Drain first with nephrostomy or new stent, treat infection, then remove 1
Do not underestimate stone burden - preoperative imaging is essential to plan the appropriate combination of techniques 3
Avoid excessive force during removal - if resistance is encountered, use laser or scissors to release tissue ingrowth rather than pulling 7
Fragmented stents require special attention - approximately 17.6% of forgotten stents fragment, necessitating piece-by-piece removal 2
Post-Procedure Management
- Stone-free status is achievable in all patients with appropriate multimodal approach 2, 8
- Complications are generally minor (Clavien grade I-II) when proper technique is used 2
- Verify complete removal with follow-up imaging at one month 2
The key principle is that complete stone and stent removal is the goal 4, requiring flexible use of multiple endoscopic modalities based on encrustation pattern rather than a single standardized approach.