Nplate (Romiplostim) Reconstitution for Subcutaneous Administration
Reconstitute Nplate with Sterile Water for Injection, USP only—never use Bacteriostatic Water for Injection or Bacteriostatic Sodium Chloride—and gently swirl (DO NOT SHAKE) until dissolved, which typically takes less than 2 minutes 1.
Reconstitution Protocol by Vial Strength
The reconstitution volume depends on the vial strength and whether dilution is needed based on the calculated patient dose 1:
For Calculated Doses ≥23 mcg (No Dilution Required)
- 125 mcg vial: Add 0.44 mL Sterile Water → Final concentration 500 mcg/mL
- 250 mcg vial: Add 0.72 mL Sterile Water → Final concentration 500 mcg/mL
- 500 mcg vial: Add 1.2 mL Sterile Water → Final concentration 500 mcg/mL
For Calculated Doses <23 mcg (Dilution Required)
After initial reconstitution with Sterile Water, add 0.9% Sodium Chloride Injection directly to the vial to achieve 125 mcg/mL final concentration 1:
- 125 mcg vial: 0.44 mL Sterile Water + 1.38 mL Normal Saline
- 250 mcg vial: 0.72 mL Sterile Water + 2.25 mL Normal Saline
- 500 mcg vial: 1.2 mL Sterile Water + 3.75 mL Normal Saline
Critical Reconstitution Steps
Add the Sterile Water directly to the vial, then gently swirl and invert—avoid excess or vigorous agitation and DO NOT SHAKE 1. This is emphasized repeatedly in the FDA labeling because shaking can denature the protein and compromise functionality 2.
The reconstituted solution should be clear and colorless. Visually inspect for particulate matter or discoloration; do not administer if either is present 1.
Dose Calculation and Administration
- Calculate patient dose: Weight (kg) × Prescribed dose (mcg/kg)
- Calculate volume to administer: Calculated dose ÷ Final concentration
- Use a syringe with 0.01 mL graduations for accurate measurement
- Round volume to nearest hundredth mL 1
Administer only subcutaneously—never intravenously—as a single weekly injection 1. For ITP, the initial dose is 1 mcg/kg weekly for both adults and children, with adjustments based on platelet response (maximum 10 mcg/kg) 3, 1.
Storage and Stability
Reconstituted Nplate (with Sterile Water only, not further diluted) can remain in the original vial at room temperature 25°C (77°F) or refrigerated at 2°C to 8°C (36°F to 46°F) for up to 24 hours 1. However, protect from light exposure, as romiplostim is particularly sensitive to light-induced functional degradation 2.
Discard any unused portion after single use—do not pool unused portions from vials 1.
Common Pitfalls to Avoid
- Never shake the vial: This is the most critical error that can denature the protein 1, 2
- Never use bacteriostatic diluents: Only Sterile Water for Injection for reconstitution and 0.9% Sodium Chloride for dilution 1
- Avoid light exposure: Keep vials protected from light during storage and handling 1, 2
- Do not administer IV: Subcutaneous route only to prevent overdose risk 1
- Use proper syringe graduations: 0.01 mL graduations required for accurate low-dose measurement 1