How should I prepare and administer an intravenous insulin infusion by adding 50 units of regular insulin to 100 mL of normal saline to start at a rate of 5 units per hour?

Medical Advisory BoardAll articles are reviewed for accuracy by our Medical Advisory Board
Educational purpose only • Exercise caution as content is pending human review
Article Review Status
Submitted
Under Review
Approved

Last updated: April 11, 2026 • View editorial policy

Have a follow-up question?

Our Medical A.I. is used by practicing medical doctors at top research institutions around the world. Ask any follow up question and get world-class guideline-backed answers instantly.

How to Prepare and Administer IV Insulin Infusion: 50 Units in 100 mL NS at 5 Units/Hour

Add 50 units of regular insulin to 100 mL of 0.9% normal saline, flush the IV tubing with 20 mL of the solution, then set the infusion pump to run at 10 mL/hour to deliver 5 units of insulin per hour 1, 2.

Preparation Steps

Solution Preparation

  • Draw up 50 units of regular insulin (Humulin R U-100 or equivalent) using a U-100 insulin syringe
  • Add the 50 units to a 100 mL bag of 0.9% sodium chloride (normal saline)
  • This creates a concentration of 0.5 units/mL (50 units ÷ 100 mL = 0.5 units/mL)
  • Mix gently by inverting the bag several times
  • Label the bag clearly with insulin concentration, date, and time prepared 1

Critical Tubing Preparation

Flush the IV tubing with 20 mL of the insulin solution before connecting to the patient 2. This step is essential because:

  • Insulin adsorbs to plastic IV tubing, reducing delivered concentration
  • A 20 mL flush minimizes adsorption losses to clinically insignificant levels (3.4% loss)
  • Priming volumes less than 20 mL result in 15.8% insulin loss without prime, and 6.6% loss with only 10 mL prime
  • No dwell time is needed - you can start the infusion immediately after the 20 mL flush 3

Infusion Rate Calculation

To deliver 5 units/hour with a 0.5 units/mL concentration:

  • Rate = (Desired units/hour) ÷ (Concentration in units/mL)
  • Rate = 5 units/hour ÷ 0.5 units/mL = 10 mL/hour

Administration Guidelines

Monitoring Requirements

  • Check blood glucose every 1-2 hours during insulin infusion 4
  • Monitor potassium levels closely to avoid hypokalemia 1
  • Use point-of-care glucose meters for bedside testing 4

Safety Considerations

  • Use only regular insulin (short-acting) for IV infusions - never use long-acting or intermediate-acting insulins 1
  • Inspect the insulin solution before use - it must be clear and colorless 1
  • Do not use if cloudy, thickened, discolored, or contains particles 1
  • Use polyvinyl chloride (PVC) or polypropylene infusion bags and tubing 1

Storage and Stability

  • Prepared insulin infusions are stable for 48 hours refrigerated (2-8°C), then an additional 48 hours at room temperature 1
  • Total maximum use time: 96 hours from preparation

Common Pitfalls to Avoid

  1. Wrong concentration calculation: Always double-check your math. With 50 units in 100 mL, you have 0.5 units/mL, not 1 unit/mL
  2. Inadequate priming: Skipping the 20 mL flush results in significant underdosing initially 2
  3. Using wrong insulin type: Only regular insulin is approved for IV use 1
  4. Infrequent glucose monitoring: Checking every 4 hours leads to hypoglycemia rates >10% 4
  5. Forgetting potassium monitoring: IV insulin drives potassium intracellularly and can cause dangerous hypokalemia 1

Target Blood Glucose Ranges

Based on patient population 4, 5:

  • Critically ill surgical patients: 80-110 mg/dL
  • Other medical/surgical patients: 90-140 mg/dL
  • Pregnant women: 70-100 mg/dL

The infusion rate should be adjusted based on your institution's protocol to maintain glucose within target range while avoiding hypoglycemia.

References

Professional Medical Disclaimer

This information is intended for healthcare professionals. Any medical decision-making should rely on clinical judgment and independently verified information. The content provided herein does not replace professional discretion and should be considered supplementary to established clinical guidelines. Healthcare providers should verify all information against primary literature and current practice standards before application in patient care. Dr.Oracle assumes no liability for clinical decisions based on this content.