Strengthen the Correction Factor First, Then Adjust Basal Rates
For persistent daytime hyperglycemia with Control-IQ enabled, the most impactful adjustment is to make the correction factor more aggressive (stronger), followed by increasing daytime basal rates if needed. 1
Primary Recommendation: Optimize Correction Factor
The correction factor (insulin sensitivity factor) is the single most powerful lever to improve time-in-range in Control-IQ users without significantly increasing hypoglycemia risk 1. Your current daytime correction factor of 1:13 means 1 unit of insulin lowers blood glucose by 13 mg/dL.
Action steps:
- Strengthen the daytime correction factor from 1:13 to approximately 1:10-1:11 (meaning each unit drops glucose more, so the system delivers more corrective insulin)
- This allows Control-IQ's automated corrections and Autobolus feature (which delivers up to once per hour) to be more aggressive in bringing down elevated glucose 2
- The real-world data from over 20,000 Control-IQ users demonstrates that more aggressive correction factors predict higher time-in-range with only negligible impact on hypoglycemia 1
Secondary Adjustment: Increase Daytime Basal Rates
After optimizing the correction factor, if hyperglycemia persists:
Increase the 6 AM to 12 PM basal rate from 2.6 U/h by 10-20% (to approximately 2.9-3.1 U/h) 3, 4
- Most patients require only 1-2 basal rate segments, so your current setup is appropriate 5
- Make conservative adjustments of 10% at a time and reassess after 3-5 days 4
- Higher basal rates do predict increased time-in-range but carry slightly more hypoglycemia risk than correction factor adjustments 1
Critical Considerations for Control-IQ Systems
Understand what Control-IQ can and cannot adjust: 3
- Control-IQ automatically modulates basal insulin delivery every 5 minutes and delivers automated correction boluses
- The system's aggressiveness depends entirely on your programmed settings (basal rates, correction factors, carb ratios)
- If your baseline settings are too conservative, Control-IQ cannot overcome inadequate dosing
Ensure manual mode settings are updated: 3
- When Control-IQ reverts to manual mode (sensor issues, system alerts), it uses your programmed basal rates
- These should reflect current insulin needs, not outdated conservative settings
Common Pitfalls to Avoid
- Don't assume the algorithm will fix everything - Control-IQ works within the constraints of your programmed settings 3
- Don't adjust too many parameters simultaneously - Change correction factor first, assess for 3-5 days, then adjust basal if needed 1, 4
- Don't forget about bolusing - The number of user-initiated meal boluses per day is the strongest predictor of glycemic outcomes, even more than pump settings 1
Monitoring Response
After strengthening the correction factor:
- Review CGM data after 3-5 days focusing on daytime time-in-range (70-180 mg/dL)
- Check for any increase in time below 70 mg/dL (should be minimal with correction factor changes) 1
- If daytime hyperglycemia persists despite optimized correction factor, then proceed with basal rate increases
The evidence strongly supports that correction factor optimization is both safer and more effective than basal rate adjustments alone for Control-IQ users 1, making this the logical first intervention for persistent daytime hyperglycemia.