Cervical Collar Cleaning Protocol
Clean cervical collars between patients using soap and water, or if visibly soiled with blood or body fluids, clean and then disinfect with an EPA-registered hospital disinfectant with low- to intermediate-level activity (tuberculocidal claim if blood-contaminated). 1
Cleaning Protocol Algorithm
For Reusable Cervical Collars
Step 1: Remove Gross Contamination
- Remove the collar from the patient wearing appropriate PPE (puncture- and chemical-resistant utility gloves, protective clothing, protective eyewear/face shield, and mask) 1
- Wipe away any visible blood, saliva, or other potentially infectious material (OPIM) with absorbent material
Step 2: Clean with Soap and Water
- Wash the collar thoroughly with soap and water to remove organic debris 1
- This cleaning step is mandatory before any disinfection, as organic material interferes with disinfectant efficacy
Step 3: Disinfect (If Contaminated with Blood/Body Fluids)
- If visibly soiled with blood or body fluids, apply an EPA-registered hospital disinfectant with:
- Low-level activity (HIV and HBV label claims) for routine contamination
- Intermediate-level activity (tuberculocidal claim) if blood-contaminated 1
- Follow manufacturer's instructions for contact time and application 1
- Do NOT use liquid chemical sterilants/high-level disinfectants for environmental surface disinfection 1
Step 4: Rinse and Dry
- Rinse thoroughly with water if required by disinfectant manufacturer
- Allow to air dry completely before storage or reuse
Step 5: Storage
- Store cleaned collars in covered or closed cabinets to prevent recontamination 1
Critical Caveats and Pitfalls
PPE Requirements
Always wear appropriate PPE during cleaning: puncture- and chemical-resistant utility gloves, protective gown/lab coat, and eye protection with face shield 1. This protects against both bloodborne pathogens and chemical exposure from disinfectants.
Product Selection
- Use only EPA-registered hospital disinfectants—never use liquid chemical sterilants for surface disinfection 1
- Prepare fresh disinfecting solutions daily as instructed by manufacturer 1
- Verify the disinfectant is compatible with the collar material (consult manufacturer if needed)
Cleaning Frequency
- Clean between each patient use 1
- Clean immediately if visibly soiled during use 1
- Clean at least daily while in continuous use on the same patient 2
Common Mistakes to Avoid
- Never skip the soap and water cleaning step before disinfection—organic material blocks disinfectant action
- Never "top off" partially empty disinfectant dispensers—this can lead to contamination 1
- Never reuse single-use disposable collars—they cannot be adequately cleaned or disinfected
- Do not use the same cleaning cloths repeatedly without proper decontamination—clean and dry mops/cloths after use or use single-use disposable materials 1
Skin Care Considerations
While cleaning the collar, recognize that prolonged collar use causes skin breakdown and pressure ulcers 3, 4, 5, 6. During collar changes for cleaning:
- Inspect skin for pressure points, redness, or breakdown 4, 5, 6
- Stabilize the head and neck manually during collar removal and replacement 4
- Clean and dry the patient's skin before reapplying the collar 5, 6
Special Circumstances
For Blood Spills on Collars: Contain, clean with soap and water, then decontaminate with EPA-registered hospital disinfectant with low- to intermediate-level activity depending on spill size and surface porosity 1, 7
For Collars Used in Isolation Settings: Follow standard precautions plus any additional transmission-based precautions. The collar itself becomes contaminated and requires the same cleaning protocol, but disposal of cleaning materials must follow isolation protocols.