Vancomycin Pump Settings for Nurses
For intermittent infusion, dilute each dose in at least 100 mL of compatible IV fluid (200 mL for 1 gram doses) and infuse over at least 60 minutes at a rate not exceeding 10 mg/min to prevent infusion-related reactions. 1
Standard Intermittent Infusion Setup
Volume and Dilution
- Minimum diluent volume: 100 mL for doses ≤500 mg; 200 mL for 1 gram doses 1
- Maximum concentration: 5 mg/mL (can use up to 10 mg/mL in fluid-restricted patients, but this increases infusion reaction risk) 1
- Compatible diluents: 5% Dextrose, 0.9% Normal Saline, Lactated Ringer's 1
Infusion Rate Calculation
The rate must satisfy BOTH of these requirements—use whichever gives the slower rate:
Practical examples:
- 500 mg dose in 100 mL: Infuse over 60 minutes minimum (rate = 100 mL/hr), since 500 mg ÷ 60 min = 8.3 mg/min (acceptable)
- 1000 mg dose in 200 mL: Infuse over 100 minutes minimum (rate = 120 mL/hr), since 1000 mg ÷ 100 min = 10 mg/min (at maximum rate)
- 1500 mg dose in 250 mL: Infuse over 150 minutes minimum (rate = 100 mL/hr), since 1500 mg ÷ 150 min = 10 mg/min
- 2000 mg dose in 400 mL: Infuse over 200 minutes minimum (rate = 120 mL/hr)
Continuous Infusion Alternative
For critically ill patients where continuous infusion is ordered 2:
- Loading dose: 15-20 mg/kg over 2 hours (up to 35 mg/kg in severe MRSA) 2
- Maintenance: 30-40 mg/kg/day (up to 60 mg/kg/day) as continuous infusion 2
- Target steady-state concentration: 20-25 mg/L 2
- Requires dedicated IV line due to incompatibility with many ICU medications 2
Critical Safety Points
Common pitfalls to avoid:
- Never exceed 10 mg/min infusion rate—this is the primary cause of "Red Man Syndrome" (flushing, hypotension, rash) 1
- Never infuse faster than 60 minutes regardless of dose size 1
- For doses >1000 mg, calculate the time needed to stay ≤10 mg/min: divide total mg by 10 to get minimum minutes
- Vancomycin has low pH and is incompatible with many drugs—use dedicated line or flush thoroughly between medications 2
Special Populations
Obese Patients
- Use actual body weight for dose calculations 2
- Loading doses up to 3000 mg maximum 2
- May require longer infusion times due to larger doses
Renal Impairment
- Doses and intervals will be adjusted by prescriber based on creatinine clearance 1
- Same infusion rate rules apply (≤10 mg/min, ≥60 minutes) 1
Dialysis Patients
- Hemodialysis: Give maintenance doses during final 60-90 minutes of dialysis 2
- CRRT: Loading dose 20-25 mg/kg, then maintenance every 12 hours or continuous infusion 2
Pump Programming Summary
Enter these values:
- Volume to be infused (VTBI): Total volume of diluted vancomycin (100-400 mL typically)
- Rate: Calculate as (Total volume in mL) ÷ (Infusion time in hours)
- Infusion time = greater of either 1 hour OR (total mg ÷ 10 mg/min ÷ 60 min/hr)
- Drug amount: Document total mg of vancomycin for pharmacy records
Always verify the ordered dose makes pharmacologic sense based on patient weight and renal function—typical adult doses range 15-20 mg/kg every 8-12 hours for normal renal function 2.